Fly-Back Chronographs
www.tissot.ch
105_E / 02.03
3/4
Alarm
Crown in position I
➊ Select the « Set Alarm » mode.
➋ Set the alarm minute using pusher A.
➌ Set the alarm hour using pusher B.
➍ Exit the « Set Alarm » mode.
Notes :
The 30 minute counter hand is set at the « Set Alarm » position. When the alarm time is set, the alarm is
activated (ON). Your watch will exit the « Set Alarm » mode if no settings are made within 15 seconds.
The red hand (3) always shows the alarm time and the 1/10 second counter hand (7) indicates whether the
alarm is switched on.
Crown in position I
B Ringing test
C ON/OFF (activated/deactivated)
Notes :
An audible signal indicates that the alarm is switched on (ON). The ringing can be stopped by pressing any
pusher. These functions are not available if the chronograph is running or on hold.
A
B
D
1
3
2
4
3
7
BC
Chronograph (simple function)
The simple « chronograph function » enables you to measure isolated events.
Crown in position I
➊ START/STOP
➋ STOP ➞ Reading the time
➌ Reset counters to zero
Notes :
The 60 second, chrono and 30 minute hands return to 0 for all chronograph functions, while the 1/10 second
counter hand shows the alarm status (ON/OFF).
3
A
B
4
5
1
2
Synchronizing
Synchronizing of the internal clock is carried out as follows :
–
When the small second hand (8) is at 60 seconds, pull the crown to position III (the hand stops).
– Using pusher A, set the 60 second hand (4) over the minute hand (2).
–
Using pusher B, set the alarm hour hand (3) (red hand) over the analogue hour hand (1).
– Then, press the crown back into position I (and tighten it down if you have a model with a screwed crown).
The internal clock is now synchronized.
Note :
Rapid synchronization (particularly useful when changing time zones) by + or - 1 hour can be carried out using
both pushers D and C.
Important :
Before synchronizing the watch, check that hands (3) and (4) and counter hands (6) and (7) are at position 0 (at
12 o'clock) with the crown pulled to position II (see Setting the counters to zero).
Chronograph (ADD function)
The ADD function enables you to measure consecutive events without having to reset to zero between each
event. Each time recorded is simply added to the previous total.
Crown in position I
➊ START
➋ STOP ➞ Reading the time
➌ RESTART
STOP ➞ Reading the time
Reset counters to zero
1
2
3
4
5
A
B
AD
BC
8
7
2
3
1
4
6
(4 Seiten)
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern